Jump to content

Capillary wave

From Wikipedia, the free encyclopedia
(Redirected from Capillary waves)
Capillary waves (ripples) in water
Ripples on Lifjord in Øksnes Municipality, Norway
Capillary waves produced by droplet impacts on the interface between water and air.

A capillary wave is a wave traveling along the phase boundary of a fluid, whose dynamics and phase velocity are dominated by the effects of surface tension.

Capillary waves are common in nature, and are often referred to as ripples. The wavelength of capillary waves on water is typically less than a few centimeters, with a phase speed in excess of 0.2–0.3 meter/second.

A longer wavelength on a fluid interface will result in gravity–capillary waves which are influenced by both the effects of surface tension and gravity, as well as by fluid inertia. Ordinary gravity waves have a still longer wavelength.

When generated by light wind in open water, a nautical name for them is cat's paw waves. Light breezes which stir up such small ripples are also sometimes referred to as cat's paws. On the open ocean, much larger ocean surface waves (seas and swells) may result from coalescence of smaller wind-caused ripple-waves.

Dispersion relation

[edit]

The dispersion relation describes the relationship between wavelength and frequency in waves. Distinction can be made between pure capillary waves – fully dominated by the effects of surface tension – and gravity–capillary waves which are also affected by gravity.

Capillary waves, proper

[edit]

The dispersion relation for capillary waves is

where is the angular frequency, the surface tension, the density of the heavier fluid, the density of the lighter fluid and the wavenumber. The wavelength is For the boundary between fluid and vacuum (free surface), the dispersion relation reduces to

Gravity–capillary waves

[edit]
Dispersion of gravity–capillary waves on the surface of deep water (zero mass density of upper layer, ). Phase and group velocity divided by as a function of inverse relative wavelength .
 • Blue lines (A): phase velocity, Red lines (B): group velocity.
 • Drawn lines: dispersion relation for gravity–capillary waves.
 • Dashed lines: dispersion relation for deep-water gravity waves.
 • Dash-dotted lines: dispersion relation valid for deep-water capillary waves.

When capillary waves are also affected substantially by gravity, they are called gravity–capillary waves. Their dispersion relation reads, for waves on the interface between two fluids of infinite depth:[1][2]

where is the acceleration due to gravity, and are the mass density of the two fluids . The factor in the first term is the Atwood number.

Gravity wave regime

[edit]

For large wavelengths (small ), only the first term is relevant and one has gravity waves. In this limit, the waves have a group velocity half the phase velocity: following a single wave's crest in a group one can see the wave appearing at the back of the group, growing and finally disappearing at the front of the group.

Capillary wave regime

[edit]

Shorter (large ) waves (e.g. 2 mm for the water–air interface), which are proper capillary waves, do the opposite: an individual wave appears at the front of the group, grows when moving towards the group center and finally disappears at the back of the group. Phase velocity is two thirds of group velocity in this limit.

Phase velocity minimum

[edit]

Between these two limits is a point at which the dispersion caused by gravity cancels out the dispersion due to the capillary effect. At a certain wavelength, the group velocity equals the phase velocity, and there is no dispersion. At precisely this same wavelength, the phase velocity of gravity–capillary waves as a function of wavelength (or wave number) has a minimum. Waves with wavelengths much smaller than this critical wavelength are dominated by surface tension, and much above by gravity. The value of this wavelength and the associated minimum phase speed are:[1]

For the airwater interface, is found to be 1.7 cm (0.67 in), and is 0.23 m/s (0.75 ft/s).[1]

If one drops a small stone or droplet into liquid, the waves then propagate outside an expanding circle of fluid at rest; this circle is a caustic which corresponds to the minimal group velocity.[3]

Derivation

[edit]

As Richard Feynman put it, "[water waves] that are easily seen by everyone and which are usually used as an example of waves in elementary courses [...] are the worst possible example [...]; they have all the complications that waves can have."[4] The derivation of the general dispersion relation is therefore quite involved.[5]

There are three contributions to the energy, due to gravity, to surface tension, and to hydrodynamics. The first two are potential energies, and responsible for the two terms inside the parenthesis, as is clear from the appearance of and . For gravity, an assumption is made of the density of the fluids being constant (i.e., incompressibility), and likewise (waves are not high enough for gravitation to change appreciably). For surface tension, the deviations from planarity (as measured by derivatives of the surface) are supposed to be small. For common waves both approximations are good enough.

The third contribution involves the kinetic energies of the fluids. It is the most complicated and calls for a hydrodynamic framework. Incompressibility is again involved (which is satisfied if the speed of the waves is much less than the speed of sound in the media), together with the flow being irrotational – the flow is then potential. These are typically also good approximations for common situations.

The resulting equation for the potential (which is Laplace equation) can be solved with the proper boundary conditions. On one hand, the velocity must vanish well below the surface (in the "deep water" case, which is the one we consider, otherwise a more involved result is obtained, see Ocean surface waves.) On the other, its vertical component must match the motion of the surface. This contribution ends up being responsible for the extra outside the parenthesis, which causes all regimes to be dispersive, both at low values of , and high ones (except around the one value at which the two dispersions cancel out.)

See also

[edit]
[edit]

Notes

[edit]
  1. ^ a b c Lamb (1994), §267, page 458–460.
  2. ^ Dingemans (1997), Section 2.1.1, p. 45.
    Phillips (1977), Section 3.2, p. 37.
  3. ^ Falkovich, G. (2011). Fluid Mechanics, a short course for physicists. Cambridge University Press. Section 3.1 and Exercise 3.3. ISBN 978-1-107-00575-4.
  4. ^ R.P. Feynman, R.B. Leighton, and M. Sands (1963). The Feynman Lectures on Physics. Addison-Wesley. Volume I, Chapter 51-4.
  5. ^ See e.g. Safran (1994) for a more detailed description.
  6. ^ Lamb (1994), §174 and §230.
  7. ^ a b c d e Lamb (1994), §266.
  8. ^ a b Lamb (1994), §61.
  9. ^ Lamb (1994), §20
  10. ^ Lamb (1994), §230.
  11. ^ a b Whitham, G. B. (1974). Linear and nonlinear waves. Wiley-Interscience. ISBN 0-471-94090-9. See section 11.7.
  12. ^ Lord Rayleigh (J. W. Strutt) (1877). "On progressive waves". Proceedings of the London Mathematical Society. 9: 21–26. doi:10.1112/plms/s1-9.1.21. Reprinted as Appendix in: Theory of Sound 1, MacMillan, 2nd revised edition, 1894.

References

[edit]
[edit]